Dyness PowerBox Pro
Unknown GLOBAL перевірено 20 вересня 2026 р.
Identity
| category | batteries |
| ean | — |
| generation | Pro |
| hardware_revision | — |
| legacy_name | — |
| manufacturer | Dyness |
| market_version | — |
| model | PowerBox Pro |
| mpn | — |
| product_family | Dyness PowerBox (PowerBox G2 / PowerBox Pro / PowerBox G3) |
| product_status | active |
| product_status_evidence | Listed on the dyness.com residential Low Voltage ESS index, has a live official product page, and appears in the dyness.com download centre roster; all checked 2026-09-02. |
| region | Global |
| release_year | — |
| sku | — |
| subcategory | low-voltage 48V-class wall-mounted battery |
| variant_note | Only one capacity/voltage variant (51.2 V / 200 Ah / 10.24 kWh) is published. |
Electrical
| cell_chemistry | LiFePO4 |
| cell_type | — |
| continuous_charge_current_a | 100 (recommended) |
| continuous_discharge_current_a | 100 (recommended) |
| continuous_power_kw | 5.12 |
| cycle_life | >=6000 cycles |
| depth_of_discharge_pct | 95 |
| max_charge_current_a | — |
| max_charge_power_kw | — |
| max_discharge_current_a | — |
| max_discharge_power_kw | 10.24 (published as 'Peak Power'; no duration given) |
| max_parallel_units | CONFLICT - see data_conflicts (official page says 50, MEDA Solar NZ distributor page says 5) |
| max_series_units | — |
| nominal_capacity_ah | 200 |
| nominal_energy_kwh | 10.24 |
| nominal_voltage_v | 51.2 |
| note | SAFETY-CRITICAL DISTINCTION: 5.12 kW is the NOMINAL/continuous power and 10.24 kW is the PEAK power with no stated duration - they are not interchangeable. Both the charge and discharge currents quoted (100 A) are labelled 'recommended', not maximum; no absolute maximum current is published for this model. |
| operating_voltage_max_v | 57.6 |
| operating_voltage_min_v | 44.8 |
| parallel_supported | yes |
| peak_charge_current_a | — |
| peak_discharge_current_a | — |
| peak_power_kw | 10.24 (duration not stated) |
| round_trip_efficiency_pct | — |
| series_supported | no (low-voltage parallel-only architecture) |
| system_energy_max_kwh | — |
| system_energy_min_kwh | 10.24 |
| usable_energy_kwh | 9.728 (inferred: 10.24 kWh x 95% DoD; no usable-energy figure is printed by either source) |
Physical / mechanical
| cooling_method | — |
| depth_mm | 210 |
| height_mm | 928 |
| installation_notes | — |
| ip_rating | IP65 |
| mounting_type | ['wall'] |
| rack_units | — |
| weight_kg | CONFLICT - see data_conflicts (official page 99.3 kg, MEDA Solar NZ 103 kg) |
| width_mm | 555 |
Installation
| mounting_orientation | wall-mounted |
Environment
| charge_temperature_range_c | 0C to 55C |
| discharge_temperature_range_c | -20C to 55C |
| indoor_outdoor | indoor and outdoor (IP65) |
| max_altitude_m | — |
| note | The charge and discharge windows DIFFER: charging is not permitted below 0C, discharging is permitted to -20C. |
| operating_humidity | — |
| operating_temperature_max_c | 55 |
| operating_temperature_min_c | -20 |
| storage_temperature_max_c | — |
| storage_temperature_min_c | — |
Interfaces & connectors
| bluetooth | — |
| can | yes |
| communication_ports | CAN / RS485 / RS232 |
| dry_contact | — |
| ethernet | — |
| modbus_rtu | — |
| modbus_tcp | — |
| protocol_notes | No DIP-switch protocol table was obtained; the official datasheet PDF is robots-blocked and the ManualsLib mirror of the user manual was not fetched. |
| rs232 | yes |
| rs485 | yes |
| usb | — |
| wifi | — |
Protection
| fire_suppression | — |
| heating | — |
| over_current | — |
| over_temperature | — |
| over_voltage | — |
| short_circuit | — |
| under_voltage | — |
Certifications
| note | This certification list comes only from the MEDA Solar NZ distributor page (document 2), not from a Dyness-published document. Not officially verified. |
| safety_certifications | ['CE-EMC', 'UKCA'] |
| standards | ['IEC62619', 'IEC62040', 'IEC60730', 'CEC'] |
| transport_certifications | ['UN38.3'] |
Warranty & service
| conditions | — |
| confidence | distributor-verified |
| note | No warranty period is printed on the official dyness.com PowerBox Pro page; only the distributor states 10 years. |
| summary | '10-year warranty' per the MEDA Solar NZ distributor page. |
| years | 10 |
Документи
datasheet
{# Located but never retrieved: listed, but deliberately not linked, and it
backs no stored value. #}
Dyness Powerbox Pro datasheet EN 2025-02-28 — знайдено, не отримано
rev UNKNOWN
distributor-page
Dyness Powerbox Pro wall-mounted battery 10kWh - distributor product page (MEDA Solar NZ)
rev UNKNOWN
product-page
PowerBox Pro - Low voltage residential energy storage batteries (official product page)
rev UNKNOWN
Зафіксовані конфлікти
electrical.max_parallel_units Review required
50 — Dyness official PowerBox Pro product page, spec table 'Expansion' = 'Up to 50 units in parallel'
5 — MEDA Solar NZ distributor page, 'Maximum Parallel Units: Up to 5 units in parallel'
physical.weight_kg Review required
99.3 kg — Dyness official PowerBox Pro product page, spec table 'Net Weight' = '99.3kg'
103 kg — MEDA Solar NZ distributor page, 'Weight: 103 kg'
Додаткові задокументовані параметри
Записано дослівно з джерела; поля схеми для них поки немає.
| Compatible Inverters (MEDA) | Growatt, Victron, Goodwe, and SMA |
| Dyness PowerBox Pro product page | 99.3 kg; 555x210x928 mm; IP65; >=6000 cycles |
| Dyness Powerbox-US User Manual, compatible inverter brand list | GOODWE, Solis, LUX, Sofar, DEYE(SUNSYNK), VICTRON, IMEON, Sungrow, SMA, RENAC, DELIOS, SAJ, Axpert/VMIII/MAX, Infinisolar, Growatt, Schneider Conext Series |
| Dyness Powerbox-US User Manual, file version-20230724-V2-EN (dyness.us store CDN) | Powerbox-US 51V/200Ah: nominal 51.2 V, operating range 44.8-57.6 V, 200 Ah, 10.24 kWh, nominal power 5.12 kW, peak power 10.24 kW, max charge 100 A, max discharge 100 A, bulk 57.6 V / absorption 56.5 V / float 56 V / cut-off 48 V, CAN 500K/250K and RS485 9600/115200, 'supports up to 5 Powerbox-US in parallel' |
| Expansion | Up to 50 units in parallel |
| Nominal Power | 5.12kW |
| Peak Power | 10.24kW |