⚡ANMAПобудова системAutomation, Network, Monitoring & Analytics

База знань › Batteries

Pylontech Force-H2-V2

Побудувати систему з цим продуктом

Verified distributor GLOBAL перевірено 20 вересня 2026 р.

Невирішений конфлікт щодо безпеки
Два джерела подають різні значення для цього продукту, і ніхто цього не вирішив. Характеристики нижче показано так, як їх записано, але цей продукт не можна вважати перевіреним для інженерних цілей, доки конфлікт не закрито.

Identity

category batteries
ean —
firmware {'documented_version': 'SMA requires battery firmware >= 1.2.0.R for Force-H2-V2', 'constraints': 'Inverter-side minimums differ per inverter - see documented_relationships.'}
generation V2 hardware revision
manufacturer Pylontech
market_version EU approval lists (KOSTAL, SMA) print this revision explicitly
model Force-H2-V2
mpn Battery module FH9637M; control module FC0500M-40S-V2
product_family Force H2
product_status —
region GLOBAL
release_year —
series Force (high voltage)
sku —
variant V2

Electrical

bms Control Module FC0500M-40S-V2 (internal power supply, LED status display, start / black-start buttons, power switch, Wi-Fi)
cell_chemistry Li-iron (LFP)
cell_configuration 30 cells in series per module, 3.2 V / 37 Ah per cell
communication CANBUS / Modbus RTU; CAN default 500 kbps, Modbus RTU default 9600 baud; CAN, RS485, RS232 and Link0/Link1 RJ45 ports
depth_of_discharge_pct 95
expandable_to_kwh 14.20 kWh per group per the operation manual (4 x FH9637M); up to 6 groups per system, i.e. up to 24 modules
max_charge_current_a 18.5 A normal; 42 A max @15 s
max_charge_power_w —
max_discharge_current_a 18.5 A normal; 42 A max @15 s
max_discharge_power_w —
module_capacity_ah 37
module_nominal_energy_kwh 3.552
module_nominal_voltage_v 96
modules_per_stack 2 to 4 FH9637M battery modules per group (operation manual V1.0). CONFLICTS with KOSTAL's 07/2026 sheet, which prints 2-5 modules - see data_conflicts.
nominal_energy_kwh 7.10 (2 modules) / 10.65 (3 modules) / 14.20 (4 modules) - as printed in the manual's system-configuration table
nominal_voltage_v 192 Vdc (2 modules) / 288 Vdc (3 modules) / 384 Vdc (4 modules)
parallel_units_max 6
peak_discharge 42 A for 15 seconds
round_trip_efficiency_pct 96
usable_energy_kwh UNKNOWN - the manual states a recommended depth of discharge of 95% but prints no usable-energy figure
voltage_range_v Per stack as printed: 2 modules 174-216 Vdc, 3 modules 261-324 Vdc, 4 modules 348-432 Vdc (lower discharge voltage to upper charge voltage)

Physical / mechanical

ac_terminal not applicable - DC battery
cooling —
dc_connector Supplied cables: DC+ 3 m red 8AWG, DC- 3 m black 8AWG, ground 1 m yellow-green 10AWG
depth_mm 296
dimensions_mm Stack: 450*296*822 (2 modules) / 450*296*1118 (3 modules) / 450*296*1414 (4 modules) (W*D*H, as printed)
display LED status display on the control module
enclosure_material —
height_mm 822 / 1118 / 1414 depending on stack size
module_dimensions_mm Battery module FH9637M 450*296*296 mm, 35 kg; control module FC0500M-40S-V2 450x296x190 mm; base 450x296x40 mm
mounting Floor-standing stack on a base (450x296x40 mm) fixed with 4 pcs M8x80 foundation bolts; bracket fasteners 14 x M4 screws
noise_db —
weight_kg 82 (7.10 kWh) / 117 (10.65 kWh) / 152 (14.20 kWh)
width_mm 450

Installation

cable_requirements DC+ 3 m 8AWG, DC- 3 m 8AWG, ground 1 m 10AWG, communication 3 m RJ45 x2 and 1.5 m internal RJ45; RJ45 connectors with water-proof M19 covers
commissioning Register the product at www.pylontech.com.cn/service/support for full warranty. If stored for more than 3 months, charge every six months and keep SOC no less than 90%; recommended full charge every 3 months during continuous operation for balancing.
installation_angle —
mounting_clearances More than 2 metres from heat sources; more than 0.3 metres from the battery module/rack; suggested base height >=300 mm above ground
torque UNKNOWN - no torque table was printed in the manual read; grounding resistance must be <=100 mOhm

Environment

ingress_protection IP55
max_altitude_m <2000
operating_temperature_c 0~50℃ (charge and discharge); optimum 18℃~28℃
pollution_degree —
protective_class —
relative_humidity_pct 5~95%
storage_temperature_c -20~60℃

Interfaces & connectors

app —
communication ['CAN', 'RS485', 'RS232', 'Link0/Link1 (master/slave daisy-chain)', 'Wi-Fi']
dry_contact —
meter_interface —
monitoring_portal —
protocols ['CANBUS', 'Modbus RTU']

Protection

anti_islanding not applicable - DC battery
arc_fault —
dc_switch Power switch on the control module
functions Over/under temperature, over/under voltage, over current, short-circuit (<4000 A rating), automatic cell balancing, communication-loss detection, relay-adhesion monitoring, black start (10 minutes)
insulation_monitoring —
overvoltage_category —
rcmu —
reverse_polarity —
surge_protection_ac —
surge_protection_dc —

Certifications

standards ['VDE-AR-E 2510-50', 'IEC62619', 'IEC63056', 'IEC62040-1', '2014/53/EU (RED)', 'UN38.3 (transfer certificate)', 'TUV SUD']

Warranty & service

conditions Product registration at www.pylontech.com.cn/service/support required for full warranty.
cycle_life 5,000 cycles (module level, as printed)
energy_throughput_mwh —
extension_options —
operation_life 15+ years
standard_years UNKNOWN - the operation manual requires product registration for 'full warranty' but prints no term

Документи

compatibility-list Compatibility List of Pylontech High Voltage ESS and Inverters Ver.2.40 rev Ver.2.40
compatibility-list KOSTAL PLENTICORE plus (G2) technical data sheet with all batteries, DOC03306755 rev DOC03306755
compatibility-list SMA Technical Information: SUNNY BOY STORAGE - Approved batteries, SBS-Batteries-TI-en-28 Version 2.8 rev Version 2.8
user-manual Lithium Phosphate Energy Storage System Force-H2-V2 Operation Manual (doc code 5PMPA08_00134, Force_H2_V2 V1.0) rev V1.0

Зафіксовані конфлікти

electrical.modules_per_stack Review required
2 to 4 modules per group (7.10 / 10.65 / 14.20 kWh) — Pylontech Force-H2-V2 Operation Manual V1.0 (2022-10-18)
2 to 5 modules, 174-540 V, 7.1-17.8 kWh — KOSTAL PLENTICORE plus (G2) tech sheet with all batteries DOC03306755, 07/2026
2 to 4 modules, 7.10-14.20 kWh — SMA SBS-Batteries-TI-en-28 Version 2.8
identity.mpn (control module part number) Review required
FC0500M-40S-V2 — Pylontech Force-H2-V2 Operation Manual V1.0
FC0500M-40S-V2 — KOSTAL DOC03306755 remark 'BMS module FC0500M-40S-V2 required'

Додаткові задокументовані параметри

Записано дослівно з джерела; поля схеми для них поки немає.

Black start10-minute duration
Grounding resistancemust ≤100mΩ
Short circuit rating<4000 A
Standard charge / discharge current7.4 A
document_demoted_to_mirrorhttps://www.kostal-solar-electric.com/fileadmin/downloadcenter/kse/DB/PLENTICORE-G2/DB_PLENTICORE-plus_Tec-sheet-with-all-batteries_en.pdf
documented_relationship:inverter_battery{"to_manufacturer": "KOSTAL", "to_model": "PLENTICORE series", "relationship_type": "inverter_battery", "match_level": "series", "status": "compatible", "source": "Compatibility List of Pylontech High Voltage ESS and Inverters Ver.2.40 (2025-08-15)", "source_url": "https://solsol.eu/file/view/3679/pylontech_compatibility-list-of-pylontech-high-voltage-ess-and-inverters-ver.pdf", "source_page": "Footnote to the KOSTAL row", "confidence": "manufacturer-documented", "required_accessories": "UNKNOWN", "required_firmware": "UNKNOWN", "region": "GLOBAL", "notes": "Pylontech's own footnote: 'Only Force-H1-V2 and Force-H2-V2, Force-H3 are compatible with Kostal PLENTICORE series inverter'. Series-level."}
identity.product_statusUNKNOWN - no manufacturer document read states a lifecycle status; KOSTAL still lists it in a 07/2026 approved-battery sheet